Cruise Control Module: Service and Repair

Cruise Control Module (C-CM)

Exploded View

NOTE: Front bumper cover is removed for clarity.










Removal

1. Remove the front bumper cover. REFER to Bumpers.

2. Gently pry the C-CM (Cruise-Control Module) away from the retaining studs.

- Disconnect the electrical connector.

3. If required, remove the 3 bolts and the C-CM (Cruise-Control Module) bracket assembly.



4. Inspect the C-CM (Cruise-Control Module) grommets for any damage and install new grommets as necessary.

Installation

1. If required, install the 3 bolts and the C-CM (Cruise-Control Module) bracket assembly.

- Tighten the bolts to 8 Nm (71 lb-in).

2. NOTE: If a plastic grommet breaks while the C-CM (Cruise-Control Module) is being installed, a new grommet should be installed. Firmly apply pressure to the C-CM (Cruise-Control Module) so that it seats completely in the grommets.

3. Once the C-CM (Cruise-Control Module) is installed, pull the C-CM (Cruise-Control Module) to confirm that all 3 ball studs are fully seated in the grommets.

- Connect the electrical connector.

4. Check the C-CM (Cruise-Control Module) alignment. REFER to Cruise Control Module (C-CM) (with Sensor) Adjustment.

5. Install the front bumper cover. REFER to Bumpers.