Parking Brake Cable - RH Rear

Parking Brake Cable - RH Rear

Removal

1. Release the parking brake cable tension. REFER to Parking Brake Cable Tension Release .

2. Separate the RH (Right Hand) cable from the LH (Left Hand) at the conduit equalizer and remove the cable from the wireform bracket.

3. Remove the 3 parking brake cable bracket bolts.

4. Remove the RH (Right Hand) wheel well bracket bolt.

5. Release the parking brake cable from the brake caliper and remove the cable.

Installation

1. Install the RH (Right Hand) wheel well bracket bolt.
- Tighten to 23 Nm (17 lb-ft).

2. Connect the RH (Right Hand) parking brake cable to the brake caliper.

3. Install the 3 parking brake cable bracket bolts.
- Tighten to 15 Nm (133 lb-in).

4. Connect the RH (Right Hand) parking brake cable to the LH (Left Hand) parking brake cable at the conduit equalizer and position through the wireform bracket.

5. Connect the cable at the cable-to-cable union.

6. NOTE: Make sure that the cable-to-cable union is connected to the front and rear cable before removing the brake control retaining pin and that the cable tension is reloaded slowly.
Remove the parking brake control retaining pin.

7. Inspect the parking brake system for correct operation.