Seat Cushion Cover - Power

Seat Cushion Cover - Power

Removal

NOTE: For component identification and locations, REFER to Seat - Exploded View .

1. If equipped, remove the 2 rivets and pull the pivot release handle out of the pocket.

1. Use a 5 mm (0.197 in) drill to remove the rivets.

2. If equipped, separate the pivot release cable and casing and remove the pivot release handle.

3. To install a new RH (Right Hand) cushion cover, from the RH (Right Hand) load floor flapper panel, detach the 2 wire harness retainers and disconnect the 2 electrical connectors.





4. To install a new LH (Left Hand) cushion cover, from the LH (Left Hand) load floor flapper panel, detach the 3 wire harness retainers, disconnect the electrical connector, disengage and remove the PFSM (Power-Fold Seat Module) with wire harness.





5. Remove the 2 load floor panel screws at the back of the cushion.

6. Pull out to release the retainers and remove the load floor panel.

7. Remove the screw, release the tab and remove the floor latch cover.

8. Release the cushion trim cover retainers from the cushion frame, and remove the cushion trim cover and cushion foam pad.

1. On assembly, the lower anchors and tethers for children and child safety seat tether anchor must be accessible through the cushion trim cover.






9. Remove the hog rings and the cushion cover.

Installation

1. To install, reverse the removal procedure.