Seat Cushion Cover - Manual

Seat Cushion Cover - Manual

Removal

NOTE: For component identification and locations, REFER to Seat - Exploded View .

1. Remove the 2 screw and pull the cushion handle out of the pocket.

2. Separate the pivot release cable and casing and remove the pivot release handle.

3. Remove the 2 screws on each side at the bottom of the load floor panel.

4. Pull out to release the retainers and remove the load floor panel.

- Use a suitable tool to disengage the load floor from the seat.

5. Remove the screw, release the tab and remove the floor latch cover.

6. Release the cushion trim cover retainers from the cushion frame.





7. Detach and remove the cushion cover.

Installation

1. NOTE: The lower anchors and tethers for children and child safety seat tether anchor must be accessible through the trim cover.
Position the cushion cover to the cushion foam pad and attach the retainers.

2. Secure the cushion trim cover retainers to the cushion frame.

3. Install the floor latch cover and screw.

4. Install the load floor panel.

- Install the 2 screws on each side at the bottom of the load floor panel.

5. Install the pivot release handle and attach the pivot release cable and casing.

6. Install the cushion handle and the 2 screw(s).