Power-Stow Seat Motor

Power-Stow Seat Motor

Removal

NOTE: For component identification and locations, REFER to Seat - Exploded View .

1. Remove the third row seat. REFER to Seat .

2. Pry to release the clips and remove the LH (Left Hand) and RH (Right Hand) outboard pivot covers.

3. From the RH (Right Hand) load floor flapper panel, detach the 2 wire harness retainers and disconnect the 2 electrical connectors. Position the wire harness out of the way.





4. From the LH (Left Hand) load floor flapper panel, disconnect the main feed electrical connector.

5. Remove the 4 load floor panel screws on each side at the back of the cushions.

6. Pull out to release the retainers and remove the 2 load floor panels.

7. Release all cushion cover retainers from the cushion frame.






8. Remove the 8 cushion frame-to-pivot tube assembly bolts. Remove the pivot tube assembly with stow motors.

Installation

1. Install the pivot tube assembly with stow motors. Install the 8 cushion frame-to-pivot tube assembly bolts.
- Tighten to 60 Nm (44 lb-ft).

2. NOTE: Lower anchors and tethers for children and child safety seat tether anchor must be accessible through the cushion cover.
Secure all cushion cover retainers to the cushion frame.



3. Install the 2 load floor panels and secure the retainers.

4. Install the 4 load floor panel screws on each side at the back of the cushions.

5. Connect the main feed electrical connector to the LH (Left Hand) load floor flapper panel.

6. Attach the 2 wire harness retainers and connect the 2 electrical connectors to the RH (Right Hand) load floor flapper panel.

7. Install the LH (Left Hand) and RH (Right Hand) outboard pivot covers and secure the clips.

8. Install the third row seat. REFER to Seat .