Roof Opening Panel Motor Initialization - Shade

Roof Opening Panel Motor Initialization - Shade

General Procedure

NOTE: If initializing both roof opening panel motors, initialize the sliding glass panel motor before initializing the power shade motor. REFER to Roof Opening Panel Motor Initialization - Sliding Glass Panel Roof Opening Panel Motor Initialization - Sliding Glass Panel.

NOTE: A new power shade motor will only move towards the CLOSED position and must be initialized.

NOTE: The roof opening panel motor(s) must be initialized when repairs are carried out on any part of the roof opening panel system, including whenever:
- the roof opening sliding glass or power shade motor has been removed from the roof opening panel system.
- the roof opening panel glass has been removed from the roof opening panel system.
- the roof opening panel assembly has been removed from the vehicle.
- a new roof opening sliding glass or power shade motor has been installed.
- a new roof opening panel glass has been installed.
- a new roof opening panel assembly has been installed.

1. NOTE: The driver or passenger front door must be open during the entire procedure.
Open the driver or passenger front door.

2. Turn the ignition to the ON position.

3. Pull and hold the shade control switch until the shade is in the fully closed position.

4. Complete the following within 5 seconds:

1. Cycle the ignition to the OFF position and then back to the ON position.

2. Pull the shade control switch for less than one second and release.

3. Pull and hold the shade control switch until the shade moves to the fully open position and then back to the fully closed position (this could take up to 20 seconds to start).

5. Release the switch and verify successful initialization by carrying out one-touch open and one-touch close operations.