Roof Opening Panel Alignment - Rear

Roof Opening Panel Alignment - Rear

General Procedure





1. Position the front sliding glass panel to the fully CLOSED position and the power shade to the full OPEN position.

2. Loosen the 8 rear fixed glass panel screws.

3. Adjust the rear fixed glass panel to specifications.

- Measure 12 inches from the left of the vehicle centerline and then repeat to the right of the vehicle centerline at all three locations shown in above illustration.

4. Using a 0.3 mm (0.0118 in) thick shim or similar tool, slide it around the perimeter of the glass panel to check for even tension and seal contact.

5. Tighten the 8 rear fixed glass panel screws.
- Tighten to 5 Nm (44 lb-in).