Rear Door: Adjustments

Door Alignment - Rear

General Procedure

1. Remove the door latch striker.

2. To adjust the door for in and out or up and down alignment:

- Loosen, but do not remove, the rear door hinge-to-rear door bolts enough to allow door alignment.

3. To adjust the door or front-to-back or tilt alignment:

1. Remove the front and rear door scuff plates. REFER to Scuff Plate Trim Panel .

2. Position the front seat all the way forward and down.

3. Position the lower B-pillar aside.

4. Depower the SRS (Supplemental Restraint System). REFER to Supplemental Restraint System (SRS) Depowering and Repowering - with Intelligent Access (IA) or REFER to Supplemental Restraint System (SRS) Depowering and Repowering - without Intelligent Access (IA) .

5. Disconnect the adaptive load limiter and pretensioner electrical connectors.

6. Remove the upper and lower bolts and position the safety belt retractor and pretensioner aside.

4. Adjust the door to specification. REFER to Component Description .

5. Tighten the door fasteners.

- Tighten the rear door hinge-to-rear door bolts to 55 Nm (41 lb-ft).
- Tighten the rear door hinge-to-body nuts to 30 Nm (22 lb-ft).

6. Install and adjust the door latch striker to specification. REFER to Component Description .

- Tighten to 22 Nm (16 lb-ft).

7. Install the upper and lower bolts and position the safety belt retractor and pretensioner aside.

1. Reconnect the adaptive load limiter and pretensioner electrical connectors.

2. Repower the SRS (Supplemental Restraint System). REFER to Supplemental Restraint System (SRS) Depowering and Repowering - with Intelligent Access (IA) or REFER to Supplemental Restraint System (SRS) Depowering and Repowering - without Intelligent Access (IA) .

3. Position the lower B-pillar back.

4. Position the front seat back to the original position.

5. Install the front and rear door scuff plates. REFER to Scuff Plate Trim Panel .