Solenoid Body Leadframe

Solenoid Body Leadframe

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Special Tool(s)






Removal

1. Remove the main control cover. REFER to Main Control Cover .

2. Disconnect the TR (Transmission Range) sensor electrical connector.





3. Disconnect the OSS (Output Shaft Speed) sensor electrical connector.





4. Remove the main control-to-cover seal.





5. NOTICE: Be careful not to bend or twist the leadframe or the solenoid terminals when removing the leadframe or damage can occur to the leadframe or the solenoids.

Remove the 5 screws and the leadframe from the solenoids by lifting it straight up evenly.





Installation

1. Install 307-636 in the solenoid body to align the lead frame for installation.





2. Position the leadframe on the 307-636 and carefully install the leadframe by pushing straight down into the solenoids.

3. Remove the 307-636.





4. Install the 5 leadframe screws.





5. Connect the OSS (Output Shaft Speed) sensor electrical connector.





6. Connect the TR (Transmission Range) sensor electrical connector.






7. Install the main control-to-cover seal.





8. Install the main control cover. REFER to Main Control Cover .