Output Shaft Speed (OSS) Sensor

Output Shaft Speed (OSS) Sensor

WARNING: Before beginning any service procedure, REFER to Safety Warnings . Failure to follow this instruction may result in serious personal injury.

Removal

1. Remove the main control. REFER to Main Control .

2. Remove the OSS (Output Shaft Speed) sensor bolt and the OSS (Output Shaft Speed) sensor.





Installation

1. Install the OSS (Output Shaft Speed) sensor and the OSS (Output Shaft Speed) sensor bolt.
- Torque: 10 Nm (89 lb-in).





2. Install the main control. REFER to Main Control .