Cylinder Head Assembly: Specifications

Cylinder Head

Install a new gasket, the LH (Left Hand) cylinder head and 8 new bolts. Tighten the bolts in the sequence shown below in 5 stages:
Stage 1: Tighten to 20 Nm (177 lb-in).
Stage 2: Tighten to 35 Nm (26 lb-ft).
Stage 3: Tighten 90 degrees.
Stage 4: Tighten 90 degrees.
Stage 5: Tighten 45 degrees.







Install the M6 bolt.
Tighten to 10 Nm (89 lb-in).










Install a new gasket, the RH (Right Hand) cylinder head and 8 new bolts. Tighten the bolts in the sequence shown below in 5 stages:
Stage 1: Tighten to 20 Nm (177 lb-in).
Stage 2: Tighten to 35 Nm (26 lb-ft).
Stage 3: Tighten 90 degrees.
Stage 4: Tighten 90 degrees.
Stage 5: Tighten 45 degrees.







Install the bolt.
Tighten to 10 Nm (89 lb-in).







Bolt re-usability

NOTE: The cylinder head bolts must be discarded and new bolts must be installed. They are tighten-to-yield designed and cannot be reused.




Surface Variation -- Head-to-block, Head-to-manifolds And Surface Variation -- Warpage











Camshaft Bearing Cap




RH

Install the 6 camshaft caps, mega cap, valve train oil tube and the 15 bolts in the sequence shown.







Loosen the 4 camshaft caps bolts.







Tighten the 4 bolts in the sequence shown.
Tighten bolts 8, 9, 10 and 11 to 8 Nm (71 lb-in) then an additional 45 degrees.







LH

Install the 6 camshaft caps, mega cap, valve train oil tube and the 15 bolts in the sequence shown.







Loosen the 4 camshaft caps bolts.







Tighten the 4 bolts in the sequence shown.
Tighten bolts 8, 9, 10 and 11 to 8 Nm (71 lb-in) then an additional 45 degrees.







Intake Manifold Specifications

Exhaust Manifold Specifications

Camshaft Gear/Sprocket Specifications