Door Glass Top Run - Front

Door Glass Top Run - Front

Removal

1. Remove the front door window glass. REFER to Window Glass - Front Door .

2. Remove the exterior door window glass belt moulding screw and moulding.
- To install, tighten to 0.9 Nm (8 lb-in).

3. Remove the door window glass top run.

Installation

1. NOTE: The front window motor must be initialized whenever the LH (Left Hand) or RH (Right Hand) (XLT, Limited) or LH (Left Hand) (base) front window motor is removed from the window regulator drum housing, a new window regulator is installed, a new window glass is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run. REFER to Window Motor Initialization Testing and Inspection.
To install, reverse the removal procedure.