Driveshaft Slip Yoke Boot

Driveshaft Slip Yoke Boot

















Removal

1. Remove the driveshaft. For additional information, refer to Driveshaft - Rear, One-Piece, 4.6L (3V) Driveshaft - Rear, One-Piece.

2. Index-mark the driveshaft on both sides of the driveshaft slip yoke boot.





3. Remove and discard the 2 driveshaft slip yoke boot clamps.

4. Separate the driveshaft.

5. Remove the driveshaft slip yoke boot.

Installation

1. NOTE: Grease both ends of the driveshaft.

Position the driveshaft slip yoke boot and the 2 driveshaft slip yoke boot clamps on one end of the driveshaft.

2. Align the index marks and connect the driveshaft.





3. Using the Keystone Clamp Installer, install the new driveshaft slip yoke boot.





4. Install the driveshaft. For additional information, refer to Driveshaft - Rear, One-Piece, 4.6L (3V) Driveshaft - Rear, One-Piece.