Transmission Fluid Cooler Tubes - 5R55S

Transmission Fluid Cooler Tubes - 5R55S

















Removal

1. With the vehicle in NEUTRAL, position it on a hoist. For additional information, refer to Vehicle Jacking and Lifting.

2. Using a backup wrench to hold the case fitting securely, disconnect the transmission fluid cooler tube nut-to-case fittings.





3. Remove the transmission fluid cooler tube secondary latch from the transmission fluid cooler tube.





4. Using the Transmission Cooler Line Disconnect Tool, disconnect the quick connect coupler and remove the transmission fluid cooler tube from the radiator.





5. Remove the transmission fluid cooler tube secondary latch from the transmission fluid cooler tube.





6. Using the Transmission Cooler Line Disconnect Tool, disconnect the quick connect coupler and separate the transmission fluid cooler tube from the transmission fluid cooler hose.





7. Remove the transmission fluid cooler tube bracket-to-engine nut.





8. Remove the transmission fluid cooler tube bracket from the stud.





9. Remove the transmission fluid cooler tubes from the vehicle.





Installation

1. Install the transmission fluid cooler tubes into the vehicle.





2. Install the transmission fluid cooler tube bracket onto the stud.





3. Verify the transmission fluid cooler tube case fitting torque.
- Tighten to 56 Nm (41 lb-ft).





4. NOTICE: To prevent cross threading, all transmission fluid cooler tube nuts must be hand-started before being tightened to specification.

Using a backup wrench to hold the case fittings securely, install the transmission fluid cooler tube nut-to-case fittings.

- Tighten to 40 Nm (30 lb-ft).





5. Install the transmission fluid cooler tube bracket-to-engine nut.
- Tighten to 25 Nm (18 lb-ft).





6. Connect the transmission fluid cooler tube to the transmission fluid cooler hose.





7. Install the transmission fluid cooler tube secondary latch to the transmission fluid cooler tube at the transmission fluid cooler hose.





8. Install the transmission fluid cooler tube to the radiator.





9. Install the transmission fluid cooler tube secondary latch to the transmission fluid cooler tube at the radiator.





10. Fill the transmission to the correct fluid level using clean transmission fluid and inspect for leaks. For additional information, refer to Transmission Fluid Level Check in Automatic Transmission/Transaxle &/or Transmission Control Systems.