Door Glass Top Run - Front

Door Glass Top Run - Front

Removal and Installation

NOTE: For LH front only, the front window motor must be initialized whenever the front window motor is removed from the window regulator drum housing, a new window regulator is installed, a new top run is installed or for any operation in which grease or lubricants are applied to the window regulator or glass run.

1. Remove the front door window glass. For additional information, refer to Window Glass - Front Door Window Glass - Front Door.

2. Remove the exterior moulding.

3. Remove the front door glass top run channel assembly bolt.
- To install, tighten to 12 Nm (106 lb-in).

4. Remove the front door glass top run channel assembly through the top opening of the front door.

5. To install, reverse the removal procedure.
- For LH front window only, initialize the LH front window motor. For additional information, refer to Window Motor Initialization - Front Window Motor Initialization - Front.