Seat Backrest Cover - Second Row, Bucket

Seat Backrest Cover - Second Row, Bucket

Removal and Installation

1. Remove the head restraint.

2. NOTICE: Use care when separating the backrest trim cover from the hook-and-loop strip, or the hook-and-loop strip can be torn from the backrest foam pad.

Release the backrest trim cover lower J-clip, separate the hook-and-loop fasteners, remove 2 rows of hog rings and invert the backrest trim cover as high as it will go.

3. NOTE: The inboard and outboard head restraint sleeves are not interchangeable.

NOTE: The head restraint sleeves incorporate an alignment tab that must face forward when installed.

Squeeze together the tip of the head restraint sleeve and pull the sleeve out of the frame tube.





4. Remove the seat backrest trim cover.

5. To install, reverse the removal procedure.