Selector Lever Bezel

Selector Lever Bezel





Removal
1. Remove the transmission selector lever.





2. Disconnect the transmission control switch electrical connector.





3. Slide the shift lever lower trim cover downward.





4. Remove the set screw and remove the shifter knob while routing the transmission control switch harness out of the selector lever housing.





5. Remove the bezel from the shift lever housing.

Installation





1. Install the bezel onto the shift lever housing.





2. CAUTION: Do not overtighten the set screw or damage to the shift lever knob may occur.

Install the shifter knob and set screw while routing the transmission control switch harness through the selector lever housing.
^ Tighten to 3 Nm (27 inch lbs.).





3. Slide the shift lever lower trim cover upward.





4. Connect the transmission control switch electrical connector.
5. Install the transmission selector lever.