Extension Housing Gasket

Extension Housing Gasket - 4x2

Removal
1. With the vehicle in NEUTRAL, position it on a hoist.
2. Remove the driveshaft.
3. Support the transmission with a suitable Jack.





4. Remove the transmission support insulator nuts.





5. Remove the bolts from the transmission support insulator.





6. Raise the transmission and remove the transmission support insulator.

7. CAUTION: The parking pawl, parking pawl return spring and parking pawl shaft could fall out during removal of the extension housing.





Remove the extension housing.





8. Remove and discard the extension housing gasket.

Installation





1. Clean the extension housing and install new extension housing gasket. Make sure that the park pawl is installed correctly.

2. CAUTION: Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup.





Install the extension housing.
^ Tighten to 30 Nm (22 ft. lbs.).





3. Install the transmission support insulator and lower the transmission onto the transmission support insulator.





4. Install the transmission support insulator bolts.
^ Tighten to 90 Nm (66 ft. lbs.).





5. Install the transmission support insulator nuts.
^ Tighten to 90 Nm (66 ft. lbs.).

6. Install the driveshaft.
7. Carry out fluid level check.