Battery Cable: Service and Repair

BATTERY CABLES

Part 1:

Part 2:

Removal and Installation
1. Disconnect the battery.
2. With the vehicle in NEUTRAL, position it on a hoist.
3. Remove the starter solenoid terminals protective cap.
4. Remove the starter solenoid wire cable terminal nut.
- To install, tighten to 6 Nm (53 lb-in).

5. Remove the starter solenoid positive cable terminal nut.
- To install, tighten to 13 Nm (10 lb-ft).

6. Disconnect the starter solenoid wire cable terminal.
7. Disconnect the starter solenoid positive cable terminal.
8. Remove the nut and disconnect the starter motor ground cable terminal.
- To install, tighten to 20 Nm (15 lb-ft).

9. Disconnect the power steering pressure switch electrical connector.
10. Disconnect the A/C compressor electrical connector.
11. Disconnect the oil pressure sending unit electrical connector.
12. Remove the nut and position the battery cable engine front cover bracket aside.
- To install, tighten to 20 Nm (15 lb-ft).

13. Remove the nut and position the battery cable frame bracket aside.
- To install, tighten to 9 Nm (80 lb-in).

14. Release the battery cable harness locators from the front of the engine.
15. Disconnect the 2 generator electrical connectors.
16. Position the protective cover aside, remove the nut and position the generator B+ terminal aside.
- To install, tighten to 9 Nm (80 lb-in).

17. Release the battery cable harness locator from the generator harness guide.
18. Open the BJB cover and remove the 2 BJB nuts.
- To install, tighten to 9 Nm (80 lb-in).

19. Disconnect the BJB terminal.
20. Remove the nut and position the battery cable body ground terminal aside.
- To install, tighten to 9 Nm (80 lb-in).

21. Remove the 2 battery cable harness locators from the battery tray.
22. Disconnect the battery cable harness electrical connector.
23. Remove the battery cables.
24. To install, reverse the removal procedure.