Fan Shroud: Service and Repair

Cooling Fan Shroud

Special Tool(s):

Removal and Installation
1. Remove the coolant expansion tank.





2. Remove the bolt and position the power steering fluid reservoir aside.
^ To install, tighten to 10 Nm (89 inch lbs.).

3. Remove the bolts, then unclip the upper fan shroud from the lower fan shroud and remove the upper fan shroud.
^ To install, tighten to 7 Nm (62 inch lbs.).

4. Disconnect the fan clutch electrical connector.
5. Remove the fan clutch wiring harness bracket bolt.
^ To install, tighten to 10 Nm (89 inch lbs.).





6. Using the special tools, remove the cooling fan.
^ To install, tighten to 55 Nm (41 ft. lbs.).

7. Remove the bolts and the lower fan shroud.
^ To install, tighten to 7 Nm (62 inch lbs.).

8. To install, reverse the removal procedure.