Seat Cushion - Second Row, 60 Percent, Bench

SEAT CUSHION - SECOND ROW, 60 PERCENT, BENCH







Disassembly and Assembly
1. Remove the second row, 60 percent bench seat.
2. Remove the second row, 60 percent bench seat backrest.

3. CAUTION: Use care when separating the cushion trim cover from the hook and loop strip, or the hook and loop strip can be torn from the cushion foam pad.

Release the J-clips, separate the hook and loop fasteners, remove the hog rings and the cushion trim cover.

4. Remove the cushion foam pad.
5. Remove 2 cushion pad supports.
6. Remove the screw and the release handle.
7. Remove the 3 screws and the latch cover.
8. Remove the 2 lower outboard latch bolts.
- To install, tighten to 40 Nm (30 lb-ft).

9. Remove the remaining lower inboard latch bolt.
- To install, tighten to 75 Nm (55 lb-ft).

10. CAUTION: Do not detach the latch cable from the seat latches. The latch assembly is synchronized; if disassembled, the latch assembly may not operate correctly.

Remove the latch assembly.
- Do not separate or disassemble the latch assembly components.

11. To assemble, reverse the disassembly procedure.