Seat Backrest - Rear, Bench

SEAT BACKREST - REAR, BENCH

Removal and Installation

1. Remove the rear bench seat assembly. Procedures

2. Remove the RH detachable safety belt anchor buckle end, if so equipped.
1. Release the cushion trim cover J-clips.







2. Remove the detachable safety belt anchor buckle end bolt.
- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the detachable safety belt anchor buckle end.







3. Release the J-clip and remove the pin-type retainer at the RH rear of the seat.







4. Remove the LH detachable safety belt anchor buckle end, if so equipped.
1. Release the cushion trim cover J-clips.
2. Remove the detachable safety belt anchor buckle end bolt.
- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the detachable safety belt anchor buckle end.

5. Release the J-clip and remove the pin-type retainer at the LH rear of the seat.







6. Remove the 4 seat back frame-to-seat cushion frame bolts (2 shown) and remove the seat back.
- To install, tighten to 25 Nm (18 lb-ft).

7. To install, reverse the removal procedure.
- Make sure the safety belts and buckles are accessible to the occupants after installation.