Disassembly and Assembly
FUEL CONDITIONING MODULEDisassembly
1. Remove the fuel conditioning module bowl and drain the fuel from the housing.
2. Remove and discard the fuel filter and O-ring seal.
3. Remove the bolts and the fuel pump.
- Remove and discard the O-ring seals.
4. Remove the bolts and the pressure relief valve.
- Remove and discard the O-ring seals.
5. CAUTION: Do not remove the heater pan or damage to the fuel conditioning housing will occur.
Remove the bolts and the fuel conditioning mounting bracket.
Assembly
1. Install the fuel conditioning module mounting bracket and bolts.
- Tighten to 17 Nm (13 lb-ft).
2. Install new O-ring seals on the fuel pump and lubricate with clean engine oil.
3. Install the fuel pump and mounting bolts.
- Tighten to 5 Nm (44 lb-in).
4. Install new O-ring seals on the relief valve cover and apply clean engine oil.
5. Install the pressure relief valve and bolts.
- Tighten to 5 Nm (44 lb-in).
6. Install a new O-ring seal and fuel filter on the fuel conditioning module bowl. Lubricate the O-ring seal with clean engine oil.
7. Install the fuel conditioning module bowl.
- Tighten to 13 Nm (10 lb-ft).
- Rotate the fuel conditioning module bowl until the electrical connectors line up.