Rear Seat Cushion - Second Row, 40 Percent E-Z Entry and Quad Bucket
REAR SEAT CUSHION - SECOND ROW, 40 PERCENT E-Z ENTRY AND QUAD BUCKETPart 1:
Part 2:
Disassembly and Assembly
NOTE: LH seat shown, RH similar.
1. Remove the second row, 40 percent E-Z entry seat.
2. Remove the second row, 40 percent E-Z entry seat backrest.
3. Remove the screw and the release handle.
4. Remove the 2 screws and the 2 LH latch covers.
5. Remove the 2 screws and the 2 RH latch covers.
6. CAUTION: Use care when separating the seat upholstery from the hook and loop strip, or the hook and loop strip can be torn from the seat cushion foam pad.
Release the J-clips and separate the hook and loop fasteners.
7. Release the cable from the seat riser and remove the cushion trim cover.
8. Remove the seat cushion foam pad.
9. Remove the 2 lower latch cover screws and the 2 LH lower latch covers.
10. NOTE: The left and right latches with cables are one assembly and should not be separated.
Remove the 4 latch bolts and the latch assembly.
- To install, tighten to 40 Nm (30 lb-ft).
11. Remove the 2 latch nuts and separate the latch pivot from the latch assembly.
- To install, tighten to 40 Nm (30 lb-ft).
12. NOTE: On assembly, route the cable as shown.
Remove the riser attachment cable.
13. Remove the torsion rod and the cushion pad support
14. Remove the front spring hinge bolts, springs and seat cushion frame assembly.
- To install, tighten to 23 Nm (17 lb-ft).
15. To assemble, reverse the disassembly procedure.