C-Pillar Trim Panel

C-PILLAR TRIM PANEL

Removal and Installation

Vehicles with third row seating
1. Position the second row outer seats to the forward position.

Vehicles without third row seating
2. Remove the rear seats.

All vehicles
3. Remove the C-pillar lower safety belt anchor bolt.
- To install, tighten to 40 Nm (30 lb-ft).

4. Position the door opening weatherstrip aside.
5. Remove the C-pillar trim panel.
6. To install, reverse the removal procedure.
- Be sure the hole on the back of the C-pillar upper trim panel is seated over the upper safety belt anchor bolt.