Floor Console - Rear

FLOOR CONSOLE - REAR







Removal and Installation
1. Remove the cupholder insert.
2. Remove the 2 rear floor console front bolts.
- To install, tighten to 9 Nm (80 lb-in).

3. Remove the storage compartment insert.
4. Remove the 2 rear floor console rear bolts.
- To install, tighten to 9 Nm (80 lb-in).

5. CAUTION: To prevent damage to the two plastic guide pegs located on the bottom of the console, pull the console straight up when removing.

Disconnect the electrical connector and remove the rear floor console.

6. CAUTION: To prevent damage to the two plastic guide pegs located on the bottom of the console, install the console straight down until the pegs are correctly seated in the holes.

To install, reverse the removal procedure.