Transmission Support Crossmember

TRANSMISSION SUPPORT CROSSMEMBER







Removal and Installation
1. Raise and support the vehicle.







2. Remove the 4 crossmember splash shield bolts and remove the crossmember splash shield.
- To install, tighten to 40 Nm (30 lb-ft).

3. Remove the 2 heat shield screws.
4. Support the transmission with a suitable jack.
5. Remove the 2 transmission mount nuts.
- To install, tighten to 90 Nm (66 lb-ft).







6. Remove the plastic shield on the right side of the transmission crossmember.
- To install, tighten to 9 Nm (80 lb-in).

7. Remove the 4 upper crossmember bolts.
- To install, tighten to 80 Nm (59 lb-ft).

8. Remove the 4 lower crossmember bolts.
- To install, tighten to 80 Nm (59 lb-ft).

9. Remove the transmission crossmember.
10. To install, reverse the removal procedure.