Power Steering Pump Pulley

Power Steering Pump Pulley





Special Tool(s)

Removal and Installation
Vehicles with 6.0L engine
1. Remove the engine cooling fan.

All vehicles





2. If equipped with A/C, rotate the tensioner clockwise and remove the belt from the power steering pump pulley. If not equipped with A/C, rotate the tensioner counterclockwise and remove the belt from the power steering pump pulley.

Vehicles with 5.4L and 6.8L engine
3. With the vehicle in NEUTRAL, position on a hoist.

All vehicles





4. Using the special tool, remove the pulley.
Inspect the pulley for paint marks in the web area near the hub. If there are two paint marks, discard the pulley. If there is no paint or one paint mark, use a paint pencil to mark the web area of the pulley near the hub.
5. To install, reverse the removal procedure.





6. CAUTION: Replacement of the power steering pump pulley is necessary after being removed and installed two times.

Using the special tool, install the power steering pump pulley.