Safety Belt Buckle - Front, 40/20/40 Seat, Driver and Passenger

SAFETY BELT BUCKLE - Front, 40/20/40 Seat, Driver and Passenger

Removal

All vehicles
1. Remove the affected seat.

Driver safety belt buckle







2. Disconnect the safety belt warning switch electrical connector.
- Remove the pin-type retainer from the safety belt warning switch electrical connector.

All vehicles







3. NOTE: Driver side shown, passenger side similar.

Remove the safety belt buckle.
1 Remove the safety belt buckle nut.
2 Remove the safety belt buckle.

Driver safety belt buckle







4. Remove the front inboard track-to-seat pan bolt.
5. Loosen the rear inboard track-to-seat pan bolt to allow the removal of the electrical connector.







6. Position the electrical connector as shown and pull it through the seat opening.

Installation







1. NOTE: Make sure to tighten nuts to specification.

To install, reverse the removal procedure.

2. Check the active restraint system for correct operation.