Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor

Turbine Shaft Speed (TSS) Sensor and Intermediate Shaft Speed Sensor

REMOVAL

1. With the vehicle in NEUTRAL, position it on a hoist.

2. Install a suitable high-lift transmission jack.

3. Remove the two wire harness retainers from the rear crossmember and position the wire harness out of the way.








4. Remove the transmission insulator and retainer nuts.







5. Remove the LH crossmember bolts and nuts.







6. Remove the RH crossmember bracket, bolts and nuts.
1 Remove the bracket bolts and nuts.
2 Remove the bracket.







7. Remove the RH crossmember bolts and nuts.







8. Remove the LH crossmember bolt, nut and the crossmember.
1 Remove the bolt and nut.
2 Remove the crossmember.






9. Lower the transmission enough to gain access to the turbine shaft speed (TSS) sensor and intermediate shaft speed sensor.

10. Disconnect the intermediate shaft and turbine shaft combination speed sensor electrical connector.







NOTE: Prior to removing the speed sensor, make sure that the area around the sensor is free of foreign material to prevent contamination of the transmission.

11. Remove the intermediate shaft and turbine shaft combination speed sensor.
1 Remove the bolt.
2 Remove the intermediate shaft and turbine shaft combination speed sensor.







INSTALLATION

1. Install the intermediate shaft and turbine shaft combination speed sensor.
1 Lubricate the O-ring and install the intermediate shaft and turbine shaft combination speed sensor.
2 Install the bolt.






2. Connect the intermediate shaft and turbine shaft combination speed sensor electrical connector.






3. Raise transmission into position.

4. Position the crossmember to the transmission insulator and retainer, and loosely install the nut.






5. Install the LH crossmember bolts.






6. Install the RH crossmember bolts.






7. Install the bracket and loosely install the bolts.






8. Tighten the RH crossmember bolts.






9. Tighten the transmission insulator and retainer nuts.






10. Install the wire harness and install the two retaining clips to the rear of the crossmember.