Rear

Shock Absorber

Removal and Installation

CAUTION: Suspension fasteners are critical parts because they affect performance of vital components and systems and their failure can result in major service expense. Install new parts with the same part number or an equivalent part if installation is necessary. Do not use an installation part of lesser quality or substitute design. Torque values must be used as specified during reassembly to make sure of correct retention of these parts.

CAUTION: The low pressure gas shock absorbers are charged with nitrogen gas. Do not attempt to open, puncture or apply heat to shock absorbers.

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Using a suitable Jack, support the rear axle.





3. Remove the shock absorber lower retaining nut and bolt.





4. Remove the two shock absorber-to-frame mounting bolts.
5. To install, reverse the removal procedure, using new fasteners.