Safety Belt Buckle - Second Row, 60/40, RH Side

SAFETY BELT BUCKLE - SECOND ROW, 60/40, RH SIDE

Torx Bit, Safety Belt Bolt:

Special Tool(s)

Removal and Installation

NOTE:
- New safety belt buckles, height adjusters, center adjust tongues and belts and retractors can be installed separately. However, if a safety belt assembly was in use during a collision, a new belt and retractor must be installed as well as the center adjust tongue and belt and buckle assembly, or the center adjust tongue and the cable and buckle assembly. When installing new safety belts and buckles, height adjusters, safety cables and buckles, center adjust tongues and belt and retractors, use only the parts specified in the Ford Master Parts Catalogs for the make and model of the vehicle being repaired. Safety belt assemblies must not be interchanged between vehicle models.
- Second row passenger side safety belt buckle shown, second row middle safety belt buckle similar.

1. Remove the seat back latch.







2. Remove the safety belt buckle.
1 Using special tool 501-010 (T77L-2100-A), remove the bolt.
2 Remove the safety belt buckle.

3. NOTE: Make sure to tighten bolts to specification.

To install, reverse the removal procedure.
- See the removal procedure or Specifications for torque specifications.

4. Check the restraint system for correct operation.