Engine Mount-LH

Engine Mount-LH





Special Tool(s)

All vehicles
1. Remove the radiator.
2. Remove the cooling fan stator.
3. Disconnect the LH and RH battery ground cables.





4. Loosen the clamp at the Charge Air Cooler (CAC).





5. Loosen the clamp at the turbocharger and remove the CAC duct.





6. Loosen the clamp and disconnect the CAC duct at the engine.





7. Loosen the clamp and remove the CAC duct.





8. NOTE: LH shown, RH similar.

Remove the LH and the RH motor mount nuts.

Vehicles with dual generators





9. Remove the secondary accessory drive belt.





10. Remove the bolts and the secondary accessory drive belt tensioner.





11. Remove the primary accessory drive belt.





12. Remove the bolts, bracket and secondary accessory drive belt idler pulley.





13. Remove the bolts and the primary accessory drive belt tensioner.





14. Disconnect the wire retainer, secondary generator electrical connector and B+ wire.





15. Remove the bolts and the secondary generator with mounting bracket.

Vehicles with single generator





16. Remove the primary accessory drive belt.





17. Remove the bolts and the primary accessory drive belt tensioner.

All vehicles





18. Remove the bolts and position the generator.





19. Support the hood and disconnect the hood lift assemblies.





20. Install two lifting eyes on the RH cylinder head.





21. Remove the retaining bolts for the fuel lines.





22. Disconnect the heater hose at the front cover.





23. Install one lifting eye on the LH cylinder head.





24. CAUTION: Do not use the special tool to raise the engine. Damage to the special tool or vehicle may occur.

NOTE: The ball studs may have to be removed.

NOTE: This procedure requires a second bolt hook assembly. The tools are available through Rotunda Tools with the following numbers: bolt hook 303-F070-6, handle 303-F070-8, bracket 303-F070-7 and washer 303-F070-12004.

Install the special tool.

25. NOTE: The engine must be raised evenly.

Using a lifting crane, raise the engine until the turbocharger is about to touch the cowl. Secure the engine with the special tool.





26. NOTE: Rear shown; front similar.

Remove the four motor mount bolts.





27. NOTE: Bracket shown removed for clarity.

Remove the bracket-to-engine bolts. Remove the bracket and the motor mount.

28. To install, reverse the removal procedure.
^ Fill the cooling system.