Valve Cover-RH

Valve Cover-RH
Removal and Installation
1. Remove the RH fender splash shield.





2. Loosen the clamp at the charge air cooler.





3. Loosen the clamp at the turbocharger and remove the charge air duct.





4. NOTE: Only one wiring retainer shown.

Disconnect the wiring retainers from the studs.





5. Disconnect the push pin retainer and Injection Control Pressure (ICP) electrical connector. Disconnect the glow plug module electrical connectors.





6. Disconnect the wire retainers.





7. Remove the four nuts and the glow plug module mounting bracket.





8. Disconnect the Injection Control Pressure (ICP) sensor electrical connector.





9. Remove the ICP sensor.





10. Remove the nut and position the transmission fluid indicator and tube assembly aside.





11. CAUTION: To prevent engine damage, do not use air powered tools when installing the valve cover.

NOTE: Mark the position of the valve cover bolts for valve cover bolt installation.

Remove the eleven bolts and the valve cover. Clean and inspect the valve cover gasket and install a new gasket, if necessary.





12. Remove the high pressure oil manifold to valve cover gasket.
13. To install, reverse the removal procedure.