Heating and Ventilation

HEATER CORE

Removal and Installation

NOTE: If a heater core leak is suspected, the heater core must be leak-tested before it is removed from the vehicle.







1. Clamp off and disconnect the heater water hoses from the heater core.
- Remove the quick disconnect clamps from the heater core.

2. Disengage the stops and lower the glove compartment door.







3. CAUTION: Do not attempt to bend any part of the panel/floor door lever. It is brittle and will break.

Remove the panel/floor door vacuum control motor.
1 Disconnect the vacuum line.
2 Remove the screws.
3 Rotate the vacuum control motor to disengage the lever and remove the vacuum control motor.







4. Remove the electronic blend door actuator and bracket assembly.
1 Disconnect the electrical connector and remove the two screws.
2 Rotate the blend door actuator and bracket assembly.
3 Remove the electronic blend door actuator and bracket assembly.







5. Remove the seven screws.
6. Disconnect the wiring harness retainer from the heater core cover.







7. CAUTION: The heater core cover must be raised vertically before removal to avoid damage to the heater core housing.

Remove the heater core cover.
1 Raise the heater core cover.
2 Remove the heater core cover.







8. Remove the heater core.

9. CAUTION: Position the temperature blend door manually to correctly align the actuator and the door. Do not power the actuator electrically. If it is not engaged with the temperature blend door, damage to the actuator can occur.

NOTE: Add gasket between housing and cover before installing cover.

To install, reverse the removal procedure.

10. Fill the engine cooling system.