Fan Shroud: Service and Repair

Cooling Fan Shroud-6.0L Diesel

Removal and Installation

1. With the vehicle in NEUTRAL, position it on a hoist.
2. Partially drain the cooling system.





3. Remove the radiator support brackets.





4. Remove the four pin-type retainers and pull back the sight shield.





5. With the sight shield pulled back, remove the three pin-type retainers and the two wiring retainers and position the harness rearward out of the way.





6. Remove the upper shroud retainers.





7. Disconnect the upper radiator hose and the radiator overflow hose.
8. Remove the shroud.
^ Move the radiator forward.
^ Pull up on the shroud evenly, and remove the shroud from the radiator.

9. NOTE: When installing the shroud, make sure that the aligning tabs are installed correctly in the slots.

To install, reverse the removal procedure.