Seat - Rear, Quad Bucket

SEAT - REAR, QUAD BUCKET

Torx Bit, Safety Belt Bolt:

Special Tool(s)

Disassembly and Assembly

All seats

1. Remove the rear quad bucket seat from the vehicle.







2. Remove the lower anchors and tethers for children (LATCH).
1 Unlatch the J-clips on the LATCH cover.
2 Remove the LATCH bolts.
3 Remove the LATCH.







3. NOTE: If the same armrest is being installed, the armrest plate and bolt can be reused, but install a new crown washer when installing the armrest.

Remove the armrest.
1 Pull back the Velcro� fastened armrest cover to expose the armrest bolt.
2 Remove the bolt and the crown washer.
3 Remove the armrest.







4. Remove the safety belt buckle end assembly.
1 Use the Safety Belt Bolt Torx Bit to remove the buckle end bolt.
2 Remove the safety belt buckle end.







5. Remove the detachable safety belt anchor buckle end.
1 Use the Safety Belt Bolt Torx Bit to remove the detachable safety belt anchor buckle end bolt.
2 Remove the detachable safety belt anchor buckle end.







6. Remove the right-hand seat side trim.
1 Remove the screws (one located behind the seat back latch).
2 Remove the right-hand seat side trim.







7. Remove the left-hand seat side trim.
1 Remove the screws.
2 Remove the left-hand seat side trim.







8. Remove the bolts.







9. Remove the bolt.







10. Remove the seat back.







11. Remove the seat back cover.
1 Unlatch the C-clip at the bottom of the seat back.
2 Slide the cover upward over the seat back, disengaging the Velcro(R) fasteners (not shown), and remove the seat back cover.

LH seats







12. Access and detach the J-clips from the seat backrest frame from beneath the seat backrest cover.

All seats
13. Remove the seat back cushion.







14. Remove the bolt and the seat back latch.







15. Remove the four nuts (two shown) and the seat support.







16. NOTE: On the RH side seat only, make sure the seat track is in the full rearward position to access the front seat track bolts.

Remove the seat track bolts and remove the seat track assembly.

17. On the LH side seat only, remove the two bolts from both spacer brackets and remove both spacer bracket assemblies.







18. Remove the seat cushion cover.
1 Unlatch the J-clips on all four sides of the seat cushion cover.
2 Remove the seat cushion frame from the seat cushion.
3 Remove the seat cushion cover from the seat cushion, disengaging the Velcro� fasteners (not shown).

19. Remove the seat cushion from the seat frame.

LH seats







20. Remove the bolts and the cushion support from the seat cushion frame.

All seats
21. To assemble, reverse the disassembly procedure.