Evaporator Outlet Line

EVAPORATOR OUTLET LINE

REMOVAL

NOTE:
- Installation of a new suction accumulator is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the suction accumulator.
- New O-ring seals, lubricated in clean PAG oil, must be installed before reconnecting any A/C fitting which has been disconnected.

1. Remove the air cleaner and air cleaner outlet tube.
2. Recover the refrigerant.
3. Disconnect the RH wheel speed sensor electrical connector.







4. Remove the components in the order indicated in the illustration and table.

INSTALLATION
1. To install, reverse the removal procedure.
2. Lubricate the refrigerant system with the correct amount of clean PAG oil.
3. Evacuate, leak test and charge the refrigerant system.