Main Climate Control

HEATER CORE AND EVAPORATOR CORE HOUSING, ASSEMBLY AND COMPONENTS

REMOVAL

NOTE:
- If an evaporator core leak is suspected, the evaporator core must be vacuum leak tested before it is removed from the vehicle.
- Installation of a new accumulator is not required when repairing the air conditioning system except when there is physical evidence of contamination from a failed A/C compressor or damage to the accumulator.
- New O-ring seals, lubricated in clean PAG oil, must be installed before reconnecting any A/C fitting which has been disconnected.
- Lubricate the coolant hoses with plain water only if needed.

1. Recover the refrigerant.
2. Remove the instrument panel. Refer to: Body and Frame, Interior Trim, Dashboard/Instrument Panel, Service and Repair, Removal and Installation, Service and Repair







3. Remove the components in the order indicated in the illustration and table.

Item 5: Vacuum Connector Removal Note







1. Disconnect the vacuum line connectors in the engine compartment.







2. Detach the grommet and push the vacuum lines into the passenger compartment.

INSTALLATION
1. To install, reverse the removal procedure.