Valve Cover LH

Valve Cover LH

Removal and Installation
1. Remove the intake manifold.





2. Illustration 1 of 2. Remove the components in the order indicated.





3. Illustration 2 of 2. Remove the components in the order indicated.
4. To install, reverse the removal procedure.

Item 2: Ignition Coil Electrical Connector Removal Note
1. Detach the pin-type retainer on the wiring harness near the ignition coil electrical connector.





2. Disconnect the fuel injector electrical connectors and the harness standoff clips.

Item 3: Accelerator Cable Removal Note





1. Disconnect the accelerator cable from the routing clip and position it aside.

Item 4: Spark Plug Wires Removal Note





1. Disconnect the standoff clips and position the spark plug wires aside.

Item 7: Valve Cover Gasket Removal Note





1. CAUTION: Do not use metal scrapers, wire brushes, power abrasive discs or other abrasive means to clean sealing surfaces. These tools cause scratches and gouges which make leak paths.

Clean and inspect the sealing surfaces. Install a new gasket, if necessary.