With Manufacturer's Scan Tool (WDS or NGS Tester)

On-Board Diagnostics With Diagnostic Tool

The Quick Tests can be used to diagnose the Powertrain control module, sensors, and actuators of the CD4E transaxle.
The following is a guide for using the On-Board Diagnostic (OBD) Quick Tests and the scan tool. Refer to Computers and Control Systems / Testing and Inspection. Testing and Inspection

- Quick Test 1.0 - Visual Inspection
- Quick Test 2.0 - Set Up
- Quick Test 3.0 - Key On/Engine Off
- Quick Test 4.0 - Continuous Memory
- Quick Test 5.0 - Key On/Engine Running
- Special Test Mode
- Wiggle Test Mode
- Output Test Mode
- PCM Reset Mode
- Clearing DTCs
- OBD II Drive Cycle
- Other Scan Tool Features

Other Scan Tool Features
Other diagnostic methods include the following:
- Parameter Identification (PID) access mode, used to monitor sensors and actuators.
- Freeze frame data access mode, used to view emission-related data values from specific PIDs.
- Oxygen sensor monitor mode, used to monitor the oxygen sensor.