Attachment III - Technical Information

SERVICE PROCEDURE

1. Reprogram the PCM to the latest level calibration. Use one (1) of the following two (2) methods:

^ Worldwide Diagnostic System (WDS), updated to release level B30.7 or later.

^ New Generation STAR (NGS) Tester with Rotunda Flash Cable (007-00531) and Rotunda Flash Card (007-00532). The calibration must be downloaded to a flash card using WDS updated to release level B30.7 or later.

NOTE:
If the PCM is already programmed to the latest level calibration, reprogramming is not necessary.

IF UNABLE TO REPROGRAM PCM

^ PCM replacement will not be covered under this program.

^ Prior to disconnecting the WDS from the vehicle and closing the session, call the Special Service Support Center at 1-800-325-5621.

PREPARE AUTHORIZED MODIFICATIONS LABEL





1. Obtain and prepare the Authorized Modifications Label. Describe the modification performed, and enter your P&A Code, date of repair and the recall program type and program number. See Figure 1.

2. Clean an area on the upper radiator support.

3. Apply the label to this clean area, then cover it with a clear plastic overlay.