Transfer Case-Automatic Shift Rear Seal

Seal - Rear








Special Tool(s)

Removal
1. With the transmission in NEUTRAL, raise and support the vehicle.





2. Index-mark the rear output flange and the driveshaft yoke.





3. Remove the four bolts.





4. Separate the driveshaft from the output flange, and position the driveshaft aside.





5. Index-mark the rear output flange to the rear output shaft.





6. Using the special tool to hold the rear output flange, remove the nut.





7. Remove the rear output flange.
1 Remove the output shaft yoke washer.
2 Remove the rear output flange.
3 Remove the oil seal.





8. Using the special tools, remove the oil seal.

Installation








1. To install, reverse the removal procedure.
^ Use the special tool to install the oil seal.
^ Check, and if necessary, fill the transfer case to the specified level with the specified fluid.