Cable

REMOVAL







1. Remove the screws and the accelerator control splash shield.







2. Disconnect the accelerator cable from the throttle body.







3. Squeeze the tabs and remove the accelerator cable from the bracket.







4. Disconnect the accelerator cable from the retainers.







5. Remove the accelerator cable from the rubber plunger.







6. Remove the rubber plunger from the accelerator pedal.







7. Remove the accelerator cable from the accelerator pedal.







8. Pull the accelerator cable boot to the unlock position.







9. Remove the accelerator cable boot and cable from the dash panel into the engine compartment and remove the accelerator cable.

INSTALLATION
1. To install, reverse the removal procedure.