Exhaust Gas Recirculation (EGR) Vacuum Regulator Solenoid - Vehicles Built After 03/2002

EXHAUST GAS RECIRCULATION (EGR) VACUUM REGULATOR SOLENOID - VEHICLES BUILT AFTER 03/2002

Removal and Installation
1. Disconnect the battery ground cable.







2. Remove the accelerator splash shield.







3. Disconnect the exhaust gas recirculation (EGR) vacuum regulator solenoid.
- Disconnect the electrical connector.
- Disconnect the vacuum lines.







4. Remove the bolt and remove the EGR vacuum regulator solenoid.
5. To install, reverse the removal procedure.