Brake Pedal and Bracket - Adjustable

Brake Pedal And Bracket - Adjustable

Removal and Installation
1. Disconnect the battery ground cable.





2. Remove the stoplight switch retaining pin.





3. Slide the stoplight switch and booster push rod from the brake pedal pin.





4. CAUTION: The brake pedal and the accelerator pedal must be in same position before removal. The pedals must be in the completely forward (toward the driver) or completely rearward (away from the driver) position.

Remove the brake pedal-to-accelerator pedal cable from the accelerator pedal by pulling the cable retainer outward.





5. Disconnect the brake pedal motor electrical connector.








6. NOTE: Starting at the upper left-hand nut, tighten the nuts in a clockwise pattern.

Remove the brake pedal and bracket retaining nuts and bolts.
7. Position the brake booster assembly out of the way.
8. Remove the brake pedal and bracket.

9. CAUTION: The brake pedal and the accelerator pedal must be in the same position before installation. The pedals must be in the completely rearward (away from the driver) position.

To install, reverse the removal procedure.