Roof Opening Panel Shield
ROOF OPENING PANEL SHIELDRemoval and Installation
1. Remove the roof opening panel.
2. Remove the water channel.
1. Remove the screws.
2. Remove the water channel.
3. Slide the roof opening panel shield forward halfway.
4. Disengage the roof opening panel shield spring-loaded guide feet.
1. Push the roof opening panel shield toward one side of the vehicle.
2. Lift the front portion of the roof opening panel shield upward to disengage the spring-loaded guide feet.
5. Slide the roof opening panel shield forward and release the rear guide feet.
6. NOTE: When installing the water channel, make sure that the water channel is seated on the locking clips. The LH water channel screw must be installed first.
To install, reverse the removal procedure.