Rear Bumper Cover / Fascia: Service and Repair

REAR BUMPER COVER

Special Tool(s):

Special Tool(s)


Removal and Installation
1. Disconnect the two license plate lamps.







2. Remove the four splash shield screws (two each side).







3. Remove the two rear bumper cover rivets (one each side).







4. NOTE: Align the rear bumper cover to the rear bumper beam guide holes when installing the step pads

Remove the two step pads (one each side).







5. Remove the rear bumper cover.
6. To install, reverse the removal procedure.
- Using the special tool, install the new rivets.