Pilot Bearing: Service and Repair

Special Tools:

Removal





1. Note: Only replace the transmission input shaft pilot bearing if it is damaged.

Remove the transmission input shaft pilot bearing using Impact Slide Hammer and Puller.





2. Inspect the transmission input shaft pilot bearing for:
- misalignment and looseness in the flywheel.
- needle rollers for scoring, worn or broken needle rollers, inadequate grease or discoloration.
- seal leakage.





3. CAUTION: To prevent damage, do not use cleaners with a petroleum base and do not immerse the clutch pressure plate in solvent.

Clean the clutch pressure plate using a suitable commercial alcohol-based solvent so surface is free from oil film.

Installation





1. Note: The transmission input shaft pilot bearing can only be installed with the seal facing the transmission. The transmission input shaft pilot bearing is pregreased and does not require additional lubrication. A new transmission input shaft pilot bearing must be installed whenever it is removed.

Install the (A) transmission input shaft pilot bearing using (B) Pilot Bearing Replacer.