Solenoid Valve-Rear Fill

Special Service Tool(s)

Removal
1. Connect New Generation STAR (NGS) Tester to the Data Link Connector (DLC).
2. Select the RIDE CONTROL OUTPUT screen and turn on the following solenoids to vent the entire system of air and to lower the vehicle to its lowest attainable height:
^ REAR FILL (rear fill solenoid).
^ GATE VALVE (gate solenoid[s]).
^ VENT (vent solenoid).
3. Raise and support the vehicle.
4. Remove the spare tire.





5. Remove the solenoid valve from the frame.





6. Compress the quick connect locking ring and pull out the air line.





7. Disconnect the solenoid valve electrical connector.

Installation

1. Note: When installing the air lines make sure the white air line is fully inserted into the fitting for correct installation.

To install, reverse the removal procedure.